3.
Insert quick-release pin into desired ANGLE SELECT degree hole.
Verify pin is thoroughly pushed in and the blue button is released.
4.
If using single pin repeat steps 1-4 on the other side of the loudspeaker.
Repeat this process on all elements in the array setting the angles per the report from LAPS
3.
OR
If using double pin continue to the next step.
5.
Double pin: Push the rear link bar up until it contacts the stop pin in the angle select
hole.
6.
Insert the second quick-release pin into desired ANGLE LOCK hole.
Verify pin is thoroughly pushed in and the blue button is released.
7.
Repeat steps 1-7 on the other side of the loudspeaker.
Repeat this process on all elements in the array setting the angles per the report from
LAPS 3.
en
19
Electro-Voice
Installation Manual
2015.04 | 02 | F.01U.310.953
