9
WAVE –
sets the carrier or modulation waveform: Square, Sine, Ramp Down, Ramp
Up or Triangle.
FILTER/RATE –
sets the cutoff frequency for the effect’s low pass filter.
FINE/DEPTH –
allows the musician to fine tune the carrier/modulation frequency.
COARSE –
tunes the carrier/modulation frequency over a wide range.
PRESET/TUNE FSW –
Press and release to load a preset. Press and hold to tune the
carrier to the note you play on your instrument.
EXP. PEDAL –
controls the carrier/modulation frequency.
UB: Upper-Sideband Modulation –
A standard ring modulator creates two sidebands at
a set distance from the carrier frequency. In Upper-Sideband mode, the Ring Thing
outputs the Upper Sideband to the Left Output, and the Lower Sideband to the Right
Output. See LB below for the knob functions while in UB or LB modes.
LB: Lower-Sideband Modulation –
In Lower Sideband mode the Ring Thing outputs the
Lower Sideband to the Left Output, and the Upper Sideband to the Right Output.
BLEND –
sets Wet/Dry Mix.
WAVE –
adjusts the wave shape of the carrier or modulation waveform by adding or
subtracting harmonics to the carrier’s sine wave.
FILTER/RATE –
sets the cutoff frequency for the effect’s low pass filter.
FINE/DEPTH –
allows the musician to fine tune the carrier/modulation frequency.
COARSE –
tunes the carrier/modulation frequency over a wide range.
PRESET/TUNE FSW –
Press and release to load a preset. Press and hold to tune the
carrier to the note you are playing on your instrument.
EXP. PEDAL –
controls the carrier/modulation frequency.
Pitch-Shift –
In Pitch Shift mode all notes from the guitar signal are shifted up or down
by the same amount. This mode preserves the harmonic relationships in the notes so that
the pitch shifted notes and chords sound much more like the notes that go into the Ring
Thing.
BLEND –
sets Wet/Dry Mix.
WAVE –
sets the modulation waveform: Square, Sine, Ramp Down, Ramp Up or
Triangle.
FILTER/RATE –
sets the pitch shifter’s modulation rate. Full counter-clockwise
disengages modulation.
FINE/DEPTH –
acts as both a FINE control and modulation DEPTH control. When
modulation is off, it fine tunes the pitch shift amount. When modulation is on it
sets modulation depth.
COARSE –
sets the pitch shift /- 2 Octaves. No Pitch Shift is at 12 o’clock.
PRESET/TUNE FSW –
Press and release to load a preset.
EXP. PEDAL –
controls the pitch shift amount.
