ELECTRO FREEZE CS700-FG, Operator'S Manual, Page: 29 / 68

ELECTRO FREEZE Shake Model CS700-FG
185231-17 19
7 Assembly
— continued
Figure 7-7
Important:
ALWAYS make sure the head bushing
is positioned in the head properly
(see Figure 7-4). The head is slotted
to match the key on the bushing.
Make sure the key aligns with the slot.
Failure to install the bushing properly
in the dispensing head will damage
the head.
8. Install the dispensing head onto
the freezer by tilting the top of the head
toward you; align the studs with the holes
in the head and slide toward the freezer.
As you gently rock the head toward the
freezer, align the beater shaft with the
bushing in the head.
9. Tighten the hand knobs (14)
simultaneously, finger-tight only.
Important:
Excessive force will damage the head.
Do not use tools to tighten.
10. Hook the handle (10), figure 7-5,
into the slot on the plunger (6).
11. Install the o-rings (9) onto the
spindle mixer (8). Insert spindle mixer
into the head and install the splash shield
bar (13), insert the keeper (12) through
the holes in the handle (10) and head (1)
(see Figure 7-6) and lock in place. Do not
lubricate.
12. Install the actuator rod (7).
13. Plug in the spindle mixer.
14. See Figure 7-7. Install the o-rings
(2) on the mix feed tube (1) The mix
feed tube o-rings do not need to be
lubricated.
15. Lay the mix feed tube in the
hopper pan. (Do not install the mix feed
tube at this time.)
Figure 7-6
Tube-Mix Feed
O-Ring
O-Ring
Insert-Assy. Mix
Feed