11
Water Drainage
When the water tank is full, the unit will stop automatically. When this happens
the
tank full
red code will show on the control panel. Compressor will turn itself
off as well.
Note:
Only empty the water tank when is full or before moving or storing the unit.
There are two ways to dispense collected water.
Use the tank.
When the tank is full, the unit will
automatically stop running, and the Full
indicator light will flash.
Turn around the unit and slowly pull out
the tank. Grip the middle handle securely,
and carefully pull out straight so water
does not spill. Do not rest the tank on the
floor because the bottom of the tank is
uneven and tank will fall and cause the
water to spill. Empty the water tank and
reinsert it into the dehumidifier. The tank
must be in place and securely seated for
the dehumidifier to operate again.
The dehumidifier can be re-started when the
tank is restored in its correct position.
NOTES:
When you remove the bucket, do not touch sensors or any
parts which are situated behind tank. Doing so may damage
the product. Be sure to push the tank gently all the way into
the unit. Banging the bucket against anything or failing to
push it in securely into place may cause the unit not to
operate.
Do not remove the float from the water tank. The water full
sensor will no longer be able to detect the water level
correctly without the float and water may leak from the
water tank.
2.
Continuous draining
Water can be automatically plumbed in or drained into sink, a larger
recipient or through the wall into an outside drain by attaching a
pipe to the unit (12 mm internal diameter) (not included). Insert the
pipe into the drain outlet at the back of the unit as shown in here.
Make sure the connection between pipe and the drain outlet
is tight and does not leak. Then direct the pipe to a suitable
drainage point. This unit uses gravity fall to dispose water hence the drain
All manuals and user guides at all-guides.com