3
PLUG-IN INSTALLATION USING THE ATTACHED SUPPLY POWER PLUG
Insert the power plug into the power outlet (NEMA 14-50 receptacle).
Amperage Configuration with the Electrify America App
1.
Download and install the Electrify America App on your smartphone (available for iOS and Android).
2.
Ensure that your phone’s Wi-Fi is turned on. It is not required to be connected to a network.
3.
Follow the instructions in the App to connect to your charger and configure your amperage setting.
3 Installation with Hardwiring
These installation instructions are intended for specialized electricians. Only qualified, specialized electricians
should hardwire the charger. In addition to the charger installation instructions, follow all federal, provincial
and local laws, regulations, ordinances, codes and safety standards.
This product must be properly grounded, either to a grounded, metal, permanent wiring system, or an
equipment-grounding conductor run with the supply power circuit conductors and connected to the
grounding terminal on the product.
CAUTION: To reduce the risk of fire, connect only to a circuit provided with 50 amperes maximum branch circuit
overcurrent protection in accordance with the National Electrical Code, ANSI/NFPA 70
.
1)
Remove the cosmetic and middle cover Remove the screw located at the bottom of cosmetic cover by
using T20 Torx bit.
2)
Tilt the cosmetic cover upward and separate it from the middle cover.
3)
Remove the screws using the T20 Torx bit.
4)
Place the middle cover on the body of the charger by hanging the two hooks on the back of the middle
cover to the ledges at the bottom of the body.
5)
Once the cover has been removed, open the cable management clip on the right hand side of the
enclosure to release the LED cable attached to the cover. This will allow the cover to be hung on the
bottom of the enclosure
Remove the plug cable
1)
Remove the plug cable by loosening the 3 center screws (shown as L1, L2, and PE) in the terminal block.
Do not loosen the screws securing the terminal block to the body.
2)
This product has two means of strain relief: a metal bracket on the interior of the body and a black nut on
the outside of the body.
3)
Loosen the left strain relief nut on the outside of the body.
