PARAMETER SETTING
Enter the P Parameter settings by cycling through the General Project Settings to the
end (
when display ceases flashing
) and simultaneously holding
button and
button for
3 seconds
. If required to exit at any Parameter, hold
button for
2
seconds
. Use the
button and
button to select the value and
confirm selection
by pressing the
button
. The Parameter will be saved and the LCD will enter the next P
Parameter settings.
P1 Motor Characteristic Parameter Setting
P1 Display
The P1 settings are a motor characteristic Parameter where:
P1 = Motor Gear Reduction Ratio × Number of Rotor Magnets
Rounding to a full number is necessary. The P1 setting ranges between 1 and 255.
P2 Wheel Speed Pulse Signal Setting
The P2 Parameter setting will display on the LCD after the P1 Parameter setting has been
selected and confirmed. The KT-LCD3 will display as follows:
P2 Display
18
Summary of Contents for KT-LCD3
Page 1: ...KT LCD3 User Manual ...
