page 6/6
4.4 programming the additional indoor terminals
If the installation contains just 1 indoor terminal, these steps are not necessary.
All indoor terminals leave the producer with address 1.
The main indoor terminal will
nOT
be programmed.
Operatorul 1 is programming from the main outdoor panel (address 1).
Operator 1
Main outdoor panel
Steps
Operator 2
Additional terminal
step 0
All LEDs are off.
ENTERING
programming mode
Operator 1 will hear [
BEEEEEEEEP
] in the outdoor
panel. Afterwards proceed to Step 2.
step 1
Press both keys
at the same time and
hold until Operator 1 is done programming
*
.
*
You will hear the first [
BEEP
] by touching the two keys and
the second [
BEEP
] when the terminal has been programmed
Hold the keys pressed until you hear
the second
[
BEEP
]
!
ENTERING
programming mode
step 2
Press the apartment’s key, as many times as it
is shown in the table below:
( for every key you press you hear: [
BEEP
] )
Operator 2
Main Additional 1 Additional 2 Additional 3
Indoor
terminal
×2
(twice)
×3
(three times)
×4
(four times)
Red/White LED
during programming mode
Keep holding the keys
pressed!
EXITING
programming mode
step 3
The panel makes a [
BEEP
] for confirmation.
step 3
You will hear
the second
[
BEEP
].
You can now release the keys!
EXITING
programming mode
You have succesfully programmed an indoor terminal.
Call to check!
We encourage you to program the additional indoor terminals at the head office.
With the devices laid out on a table, one operator follows the same steps.
Label the devices you program so you don’t misplace them in the installation.
4.5 functions and adjustments
1. Check
anywhere within the installation, during the
call and the communication, that the power tension
between
+14 V
⟷
GND
is higher than
12,0 V
.
2. Check
the functions of the indoor terminals and the outdoor
panels: call, communication, access, audio monitoring.
When calling from outside, all indoor terminals will ring, but
just the one you answer from can be used during the call.
The installation has been adjusted by the producer for audio
communication to suit standard functioning conditions.
how to adjust the volume of the indoor terminal:
When the
LED is Red, the terminal is silent.
By pressing the
key you change between
different volume levels (White LED).
After the verifications, leave the indoor terminal on Open Volume:
→
white LED on.
how to choose the terminal’s ringtone:
1. Simultaneously press and hold keys:
!
2. Release the keys a few seconds after
begins flashing Red/White!
3. Press
to switch between ringtones.
4. Press
to set the ringtone.
