www.elecro.co.uk
15
MODBUS Setup continued
Set Parity
Touch the ‘OK’ button key to select ‘MODBUS SET PARITY’ and ‘PARITY
ODD’ will be displayed Touch the ‘UP’ / ‘DOWN’ button keys to change
‘PARITY ODD’ to ‘PARITY EVEN’ or ‘PARITY NONE’ touch the ‘O.K’ button
key to select the required setting, the display will now revert back to show
‘MODBUS SET PARITY’ touch the ‘UP’ button key and ‘MODBUS EXIT’ will
be displayed, touch the ‘OK’ button key to select ‘EXIT’ and the display
will show ‘MODBUS’ Touch the ‘UP’ button key and the display will show
‘FACTORY’ touch again and ‘EXIT’ will be displayed, touch ‘OK’ and the
controller will exit the ‘INSTALLATION’ mode and revert to ‘NORMAL’
mode.
FACTORY Setup
This category has restricted access
ENGL
IS
H
Once configured the MODBUS connection will enable the controller to
be switched ‘on’ and ‘off’ (into and out of standby mode) remotely via an
external BMS device.
