Elecro Engineering HR-110, Installation & Operating Manual

Page: 21 / 32

2
www.elecro.co.uk
ENGL
IS
H
19
NOTE: In the event of power loss: the programmed settings (dosing volume
and dosing time) will remain stored. If the power to the controller is switched
off for longer than 3-Hours the current time will need to be re-programmed,
this is indicated to the operator by the clock flashing.
Set Current Time:
To complete the set up you need to programme the current time: Use the /
buttons until ‘SET TIME’ is displayed, Press the O.K. Button.
Use the / buttons as required to select the current time
NOTE: the time must be entered in the 24-Hour format.
The display will now revert to showing the UV lamp life remaining and the
current time.
Shock Dose:
The shock dose feature enables the operator to shock dose the pool
immediately with a chosen volume of the dispensing chemical. This may be
necessary following heavy use of the pool or a change of water conditions.
To activate the Shock Dose feature use the / buttons to scroll until
‘SHOCK DOSE’ is displayed, press the ‘O.K’ button.
Using the / buttons select the volume (in ml / millilitres) that you would
like to shock dose the pool with. When the correct value is shown, press the ‘O.K.
button to confirm. The display will show ‘SAVED’ and the shock dose will begin
immediately.
NOTE: The shock dose will only begin if the main filtration pump is operational.