12
The timer mode allows you to set up 4 on and off time periods when you would like heating to
take place. These can be set to take advantage of off-peak energy tariffs, or to ensure your pool
is at the required temperature during specific time periods.
The controller allows you to override the time clock at any point by activating the Priority of Heating
Mode explained on page 16.
Note:
The time clock will only control the heating time periods and not the filtration pump cycles.
6.5 Probe Calibration Setup
After selecting
‘EXIT’
for the timer setup the display will then show
‘PROBE CAL’
touch the
‘O.K’
button key to select, touch the
‘UP’ / ‘DOWN’
button keys to increase or decrease the temperature
calibration adjustment, touch the
‘O.K’
button key to select, the display will then revert back to
show
‘PROBE CAL’
.
Probe calibration is usually not required. However, should you need to make an adjustment take a
temperature reading from the pool water with an accurate thermometer then adjust as required.
Actual Water Temp
Heatsmart Plus Reading
Adjustment Required
28
30
-2.0
28
26
2.0