Eldes ESIM262, Manual

Page: 24 / 52

24
2. System pre-operation
and essential control commands
VERY IMPORTANT!!!
Underscore symbol ‘_’ in this manual is used to represent space. When writing SMS messages, every underscore symbol should be
replaced by single space symbol. XXXX – means password. Don’t leave any space at the beginning and the end of the message.
To set ESIM 262 system parameters easier and quicker you can use the computer, USB cable and configuration program ESIM
262 ConfigTool. You can read more in chapter 4.2.
2.1 Signal strength
Connect external power supply and watch for “PWR” indicator to
light up. “NETWORK” will start blinking when system registers with
cellular network.
Try to choose GSM antenna location with best signal strength based
on blinking frequency.
2.2 Selecting device language and verification of SMS central number
The language in which the device communicates
with the user can be chosen before changing fac-
tory default password. To change the language in
the system that is already configured reset default
settings as described in 4.1 appendix.
Send SMS message with the required language
code to the number of the SIM card inserted in
ESIM 262.
E.g., if you want to set the English language send the following SMS message: EN
30-60 seconds later you should get an SMS message: „English language confirmed.“ Go to chapter 2.2 upon reception of this message.
Otherwise check for network connection and call ESIM 262 system from your mobile and wait until the system drops the call. You should
get an SMS message asking to change default password. Otherwise check for network connection and change SMS central number.
SMS central number is saved in SIM card, therefore if SIM card has been used to send SMS messages with a mobile phone, then you
don’t’ need to change SMS central number. Often SMS central number is already saved in SIM card by cellular operator.
Central number can be entered by sending SMS message:
XXXX – is a password. Default password is four zeros: 0000. SMS central number is provided by cellular network provider.
Example: 0037069899992
Message should be sent to the number of SIM card which is placed into the system. If all went correct, the system will send a message:
SMS central number has been successfully changed to +37011111111
2.3 Password change
All SMS commands start with a password, so please memorize it well. Manufacturer default password is four zeros 0000, which is
necessary to change. Manufacturer default password can be changed by sending SMS message to ESIM 262:
ESIM 262
Language Code
lithuanian LT
english EN
russian RU
Table of possible
languages
“NETWORK” indicator blinking Meaning
OFF No network connection
Every 3 sec Poor network connection
Every 1 sec Medium network connection
Several times a sec Good network connection
Solid ON Excellent network connection
XX37011111111
0000_PSW_XXXX