elddis Buccaneer, Owner'S Handbook Manual

Page: 45 / 144

6-8
GETTING STARTED
To calibrate the Water System
Now that the water system has been primed, you must calibrate the Intelligent Control ® unit,
which is located at the back of the water socket (inside the caravan).
5 easy steps to calibrate your Watermaster
®
IC Pump
Controller
To ensure successful installation and optimum performance of the Watermaster
®
IC Unit, please
follow these 5 simple steps. You must calibrate the system.
Step 1
Press and hold the calibration button until the
green LED starts to flash after 1-3 seconds
Step 3
After approximately 30 seconds,
turn off the shower
Step 2
Open the cold shower and the pump should
start (there may be a short delay)
Step 4
After approximately 10 seconds (the pump
should still be running), press and hold the
calibration button again until the LED turns
solid green and the pump will stop after
approximately 10 seconds
Step 5
The green LED should turn off and blink briefly
every 5 seconds. The system is now
calibrated
Watermaster® IC is now installed and ready for use
During normal use, once calibrated you will only need to recalibrate if you use a different pump.
Simply repeat the steps above to calibrate a new pump.
Watermaster ® IC
Calibration Button
Calibration Button
Green Calibration Light
Screw Hole
Negative
Positive
Pump running light
Calibration Button