elddis 2016 Buccaneer, Owner'S Handbook Manual

Page: 28 / 146

5-9
ARRIVING ON SITE
Retracting the jacks
Follow the procedure below to retract the axle and corner supports.
Step 1 Press 1x on the button “ON/OFF” (no.5) to switch the levelsystem ON.
The “E&P-logo” LED lights up, indicating that the levelsystem is switched
on.
Step 2 Press 1x on the button “RETRACT ALL JACKS” (no.8) once.
The indicator LED “JACKS NOT FULLY RETRACTED” (no.4) goes out
when all jacks have been fully retracted.
Step 3 Press 1x on the button “ON/OFF” (no.5) to switch the levelsystem OFF.
IMPORTANT: Before departure ensure all supports have been retracted.
E x t r a E x t r a E x t r a E x t r a E x t r a functions
Calibration (setting the zero point)
The calibration procedure described below has already been carried out at your dealer/installer.
You don’t have to perform this procedure by yourself. E&P Hydraulics has decided to include this
chapter as an extra in this manual in case of failure and/or service & repair matters.
Consider setting the zero point** as a condition to make it possible to level the caravan
automatically and/or manually. When this operation, for some reason, has not been done or has
been carried out incorrectly, it is not possible to level the caravan.
**The zero point is the point (level) at which the hydraulic levelling system (in an automatic cycle)
returns.
Start: Manual levelling
Before automatic levelling can be activated, you must set the zero point. For setting the zero
point, you must FIRST perform the manual levelling procedure.
REMARK: Do this by placing a spirit level in the centre of the caravan.
ATTENTION! Never put the rear brackets first to the ground. This in case creating too
much load on the caravan.
ON/OFF
(no.5)
RETRACT ALL
JACKS (no.8)
4