UM120932B 1017 GB
Trouble Shooting
Replacing the Battery
If the radio receiver does not react to the
:
Check that the wireless connection at the
installation site is not impaired between
the
and the receiver.
Memorize the transmission code in the
receiver.
Other wireless devices using the same
frequency or working in direct proximity
may interfere with the device.
tranmitter
-
Check the condition of the battery.
-
transmitter
-
-
Disposal
Conformity
If, despite correct handling, faults or mal-
functions occur or if the product was da-
maged, please contact your retailer or the
manufacturer.
ELDAT GmbH
Im Gewerbepark 14
15711 Königs Wusterhausen
Germany
Phone:
+ 49 (0) 33 75 / 90 37-310
Fax:
+ 49 (0) 33 75 / 90 37-90
Internet: www.eldat.de
E-Mail:
Waste electrical products and batteries not
be disposed of with household waste!
Dispose of the waste product via a
collection point for electronic scrap
or via your specialist dealer.
Dispose of used batteries in a
recycling bin for batteries or via the
specialist trade.
Put the packaging material into the
recycling bins for cardboard, paper
and plastics.
Hereby, ELDAT GmbH declares that the
radio equipment type RTS16 is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of confor-
mity is available at the following internet
address: www.eldat.de
Warranty
Within the statutory warranty period we
undertake to rectify free of charge by repair or
replacement any product defects arising from
material or production faults.
Any unauthorized tampering with, or
modifications to, the product shall render this
warranty null and void.
Service
Controlling the Battery
The battery voltage is monitored cyclically:
-
at each change of state (transmission of
the status signal),
- at least 1x every 24 hours after the last
transmission of a status signal.
As soon as a weak battery is recognized, a
signal „Battery Low" is transmitted at least 1x
every 4 hours.
Once the battery is discharged, the red LED
flashes 3x shortly in an interval of about 20
seconds and it will be sent an undervoltage
telegram automatically. Please exchange the
battery now (see „Replacing the Battery“).
If the voltage drops further, the window contact
sensor switches off, and no state changes will
be sent to the receiver anymore.
1. Unscrew the upper part of the transmitter.
2.
Pull the battery holder out at the latch
and replace the battery. Only use batte-
ries of the type CR2032.
Make sure the poling is correct. The
positive pole has to be visible!
3.
Screw back the upper part of the trans-
mitter.
Note:
The coding of the transmiter is preser-
ved even if there is no voltage supply. You do
not need to memorize the code in the recei-
vers again after a battery change.