I02-121 User manual & maintenance guide
Version 02
(translation of the original manual)
of TLM 2000
Page
5
sur 41
4.
MAINTENANCE
General visual check
Approximately every 500 hours, check the following points to ensure the proper functioning of
the transfer system:
Belt wear
Regularly verify visually the state of the belt and especially the welding area.
Passageways of the workpiece carriers
The friction of the pins while operating can make some marks appear. Those marks may over the
long term require the part replacement.
Pins
Pins are sensitive to wear, especially if the load is heavy on the workpiece carrier. Wear can be
noticed as soon as a loss of efficiency in the guiding of the workpiece carrier occurs.
Wear of the belt guide
Belt guide must be replaced as soon as wear marks or friction on the belt start to appear.
Transfer parts
After the first 100 hours of use:
Lubricate the chain. No disassembly is needed for this operation.
Use the grease ref. 800 00 006 (Chain plus V1 spray).
Wear area of the pins
Belt
Belt guide