I02-121 User manual & maintenance guide
Version 02
(translation of the original manual)
of TLM 2000
Page
4
sur 41
3.
Ensure the perfect stability of the whole line. To achieve this and according to the lay-
out of the line, it may be necessary to perform ground fastenings,
4.
Check the settings of the motor magneto-thermic circuit breakers,
5.
Check the running direction of the belt without any load,
6.
Adjust the cams and the selectors using a workpiece carrier,
7.
Start the transfer system with all the workpiece carriers on.
3.3
Stopper
1.
Place the stopper right in the middle of the two profiles of the system,
2.
Adjust the sensor for the detection of the workpiece carriers,
3.
Adjust the flow control units.
3.4
Positioning unit
1.
Put the positioning unit right in the middle of the two profiles of the system,
2.
Adjust the sensor for the detection of the workpiece carriers,
3.
Check on the high position that the pins of the workpiece carrier are free,
4.
Lubricate the positioning units fingers with a fine layer of grease (see Maintenance),
5.
Adjust the flow controllers.
Note
: For the heavy positioning unit, check the lubrication of the drawer (see
Maintenance).
All the different types of positioning unit include several mobile parts driven by
pneumatic cylinders. Therefore, they must be well protected on the end-user
machine in order to avoid any risk of pinching or squashing. We recommend
mounting a protective housing.
3.5
Workpiece carrier
1.
Check that the springs of the pins located under the carrier are working properly.
2.
Check that no part goes over the lower surface of the workpiece carrier.