42
Installation
10.2
Installing the wall mounting bracket
The appliance is intended for wall mounting using the wall
mounting bracket supplied.
Note
◦
The wall mounting bracket can be used as a
template for wall mounting. This ensures suffi
-
cient clearance from the floor.
◦
Use a spirit level if the floor is uneven or slop
-
ing.
aaa
D
00000
72
15
9
1
3
2
4
≥183
≥183
D
00000
74
79
8
» Unhook the wall mounting bracket from the
appliance.
» Place the centred wall mounting bracket horizontally
on the floor. Mark holes 1 and 2.
» Lift up the wall mounting bracket so that its lower
holes match up with the markings you have just
made on the installation wall.
» Mark holes 3 and 4 on the installation wall.
» Drill the holes at the 4 markings.
»
Secure the wall mounting bracket with suitable fixing
materials (screws, rawl plugs). With the vertical slots,
you can compensate for an offset fixing hole.
10.3
Appliance installation
D
00000
74
794
1
1 Wall mounting bracket
» Hook the appliance onto the bottom tabs of the wall
mounting bracket by the slots in the back of the
appliance.
» Place the appliance in an upright position.
» Secure the appliance by pushing it towards the wall
until it audibly snaps into place in the two upper
springs on the wall mounting bracket.
D
00000
74
79
5
2
1
1 Appliance
2 Locking screw
» Secure the appliance against unintentional release
using the supplied locking screw on the right or left-
hand side of the wall mounting bracket.
10.4
Removing the appliance
» Undo and remove the locking screw from the wall
mounting bracket.
» To release the appliance, push down the springs at
the top of the wall mounting bracket.
» Tilt the appliance away from the wall and lift it off the
bottom tabs on the wall mounting bracket.
10.5
Electrical connection
WARNING Electrocution
◦
Carry out all electrical connection and instal
-
lation work in accordance with relevant regula
-
tions.
◦
Do not install the appliance with a fixed power
cable.
Material losses
◦
Observe the type plate. The specified voltage
must match the mains voltage.
◦
Ensure the on-site supply cable has an ade
-
quate cross-section.
The appliance is supplied fully wired (with a mains plug),
but it is also suitable for permanent connection.
