ELC sideKICK too, User Manual

Page: 7 / 15

__________________________________________________________________________________
ELC sideKICK too User Manual
Master / Slave / Operation mode
Key
Function
11 12 13 14
○ ○ ○ ○
Normal standalone operation
҉ ○ ○ ○
Device is master of a system (contains memories)
○ ҉ ○ ○
Slave in a system
҉ ҉ ○ ○
Last slave in a system (RDM signal is blocked)
○ ○ ҉ ○
DMX remote wing with offset 1
҉ ○ ҉ ○
DMX remote wing with offset 51
○ ҉ ҉ ○
DMX remote wing with offset 101
҉ ҉ ҉ ○
DMX remote wing with offset 151
In Master/Slave mode, the master device should be first in the DMX line.
The slaves are then daisy-chained to the master. In daisy-chaining, the output of the
master device is connected to the input of the slave device. The output of the slave
device can then be connected to the input of another slave device, and so on.
The master device communicates with the slave devices through RDM (bidirectional
DMX). If devices after the last slave device are not handling the RDM signal correctly,
the last slave should be programmed as slave-last (this will block the RDM signal).
Creating memories
(with faders)
To store a memory (captured from the DMX input) into one of the ten faders, follow
the next steps:
•
Press the Store button (the button will now start flashing, indicating that no
fader has been selected). The built-in merger is now disabled and will pass
through the DMX input signal.
•
Create the required memory by the external DMX source
•
Move the chosen fader to it’s full position. The S tore LED will now be on.
(If the fader is already at the full position, move it down first and back up.)
•
Selecting the same fader again will undo the selection and a different fader
can be selected.
•
Press the Store button to save the memory
Operation