__________________________________________________________________________________
ELC dmXLAN node3 User Manual
In select mode:
E/-
Select different item
Press Encoder
Go to Edit mode
In Edit mode:
E/-
Change the value of the item
Press Encoder
Go to Select mode
DMX port as output
When a port is set up as a DMX output it can operate in the following modes;
•
Disabled
à
the DMX output is disabled
•
Outzero
à
the DMX sends out a DMX test signal with all channels at 0%
•
Single
à
the output sends out the DMX values of the selected (primary)
Art-Net, sACN or Shownet universe. The DMX output is enabled the first time
it detects the DMX universe on the network (or internal DMX inputs). If the
universe on the network fails, the DMX output will go into DMX hold.
•
HTP
à
like single, but merges up to three DMX universes (primary,
secondary and tertiary) in highest takes precedence.
•
Priority
à
Will output the Universe assigned to the primary if primary is
not present or available the universe assigned to secondary will be output
•
FlexPatch
à
Can output a complex merge of three universes with a
different merge or patch per channel. This can be set up in the dmXLAN
software
DMX port as input
When a port is set up as a DMX input it can operate in the following modes;
•
Disabled
à
the DMX input does nothing
•
Normal
à
any valid DMX is sent onto the network (and internal use)
using the selected universe (Art-Net)
•
Backup
à
the DMX input will not send data if the selected universe is
present on the network. If the selected universe is not present on the network
for several seconds and the input has valid DMX, then it will send DMX data.
If another sender starts sending the same universe, the input will go back into
backup mode.
Summary of Contents for dmXLAN node3
Page 1: ...dmXLAN node3 User Manual ...
