22
•
Install the unit away from direct sunlight.
•
If possible, avoid locations near bushes, trees or pets.
•
The sensor has its highest sensitivity to movements tan-
gential to (passing straight by) the unit, and the lowest
sensitivity to radial movements directly toward or away
from the detector.
Installation:
There are four different ways of mounting the Motion Sensor:
•
Wall mounting
•
Ceiling mounting
•
Inside corner mounting
•
Outside corner mounting
1. Wall mounting
•
Unscrew and remove the front cover with a screwdriver.
•
Install the sensor unit on the wall using two screws.
•
After connecting the wires to the sensor unit, click in the
front cover and fasten it with the removed screw.
2. Ceiling mounting
•
Same procedure as wall mounting, but just install the
sensor on the ceiling.
3. Corner mounting, inside or outside
•
Mount the Corner Mounting Plate using two screws.
•
Install the sensor unit on the Corner Mounting Plate using
two screws.
•
After connecting the wires to the sensor unit, click in the
front cover and fasten it with the removed screw.
Wiring instructions:
•
Breakout one of the two holes of the seal feed-through.
•
Run the power cable through the rubber gasket.
•
Strip 6 to 8 mm from the cable.
•
Before connecting it, ensure that the cable is cleanly posi-
tioned in the feed-through ring.
2
3
4
5
6
7
