4
EN
•
To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do
not immerse the hose end into the dirty water or
drive it in the drain more than 15 cm. If it is too
long, cut it short.
•
The end of the hose should not be bent, it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
•
If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.
Adjusting the feet
A
In order to ensure that the product operates
more silent and vibration-free, it must stand level
and balanced on its feet. Balance the machine
by adjusting the feet. Otherwise, the product
may move from its place and cause crushing
and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
Do not use any tools to loosen the lock nuts.
Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. Our company shall not be liable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
•
Connection must comply with national
regulations.
•
Power cable plug must be within easy reach
after installation.
•
The voltage and allowed fuse or breaker
protection are specified in the “Technical
specifications” section. If the current value of
the fuse or breaker in the house is less than 16
Amps, have a qualified electrician install a 16
Amp fuse.
•
The specified voltage must be equal to your
mains voltage.
•
Do not make connections via extension cables
or multi-plugs.
B
Damaged power cables must be replaced by
the Authorized Service Agents.
First use
Before starting to use the product, make sure that
all preparations are made in accordance with the
instructions in sections "Important safety instructions"
and "Installation".
To prepare the product for washing laundry, perform
first operation in Drum Cleaning programme. If
your machine is not featured with Drum Cleaning
programme, use Cottons-90 programme and select
Additional Water or Extra Rinse auxiliary functions
as well. Before starting the programme, put max.
100 g of powder anti-limescale into the main wash
detergent compartment (compartment nr. II). If the
anti-limescale is in tablet form, put only one tablet into
compartment nr. II. Dry the inside of the bellow with a
clean piece of cloth after the programme has come
to an end.
C
Use an anti-limescale suitable for the washing
machines.
C
Some water might have remained in the product
due to the quality control processes in the
