Elba Domino E35-100 XD, Instructions For The Use - Installation Advices

Page: 33 / 64

33 33
GAS TAPS
Periodic lubrication of the gas taps must be
carried out by specialist personnel only.
In the event of operating faults in the gas
taps, call the Service Department.
CONTROL KNOB
The control knobs may be removed for
cleaning but care should be taken not to
damage the seal.
BURNERS AND GRIDS
These parts must be cleaned using a
sponge and soapy water or other suitable
non-abrasive products. Dry with a soft
cloth.
Warning! Not dishwasher safe.
After cleaning, the burners and their flame
spreaders must be well dried and correctly
replaced.
It is very important to check that the burner
flame spreader and the cap have been
correctly positioned. Failure to do so can
cause serious problems.
Keep the electrode clean so that the sparks
always strike.
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.
CORRECT REPLACEMENT OF THE
SEMIRAPID AND RAPID BURNERS
It is very important to check that the burner
flame spreader “ F ” and the cap “ C ” have
been correctly positioned (see figs. 3.1 and
3.2) Failure to do so can cause serious
problems.
Check that the electrode “
S ” (figs. 3.1 -
3.3) is always clean to ensure trouble-free
sparking.
Check that the probe “
T ” (figs. 3.1 - 3.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
CORRECT POSITION OF TRIPLE
RING BURNER
The triple ring burner must be correctly
positioned (see fig. 3.3); the burner rib
must be fitted in its housing as shown by
the arrow.
Then position the cap “
A ” and the ring
“ B ” (fig. 3.4 - 3.5). The burner correctly
positioned must not rotate (fig. 3.4).
Note: Continuous use may cause a
change in the glaze around the burners
and grids, corresponding to the areas
exposed to the heat. This is a natural
phenomenon and does not prevent the
parts from working properly.