Elation SMARTY HYBRID, User Manual

Page: 13 / 42

13
www.elationlighting.com
L A M P R E P L A C E M E N T
To ensure a proper/safe lamp change, carefully read all the following instructions.
THE PHILIPS™ MSD PLATINUM 200 FLEX LAMP MUST BE REPLACED
EVERY 6,000 HOURS OR WHEN DAMAGED AND/OR DEFORMED!
USE ONLY GENUINE ORIGINAL PHILIPS™ LAMPS. OTHER BRAND
LAMPS WILL CAUSE DAMAGE AND WILL VOID FIXTURE WARRANTY!
DISCONNECT THE MAIN POWER SUPPLY BEFORE REPLACING LAMP!
FIXTURE MUST COOL FOR 60 MINUTES BEFORE REPLACING LAMP!
NEVER TOUCH LAMP WITH BARE HANDS, ALWAYS WEAR GLOVES!
OIL FROM HANDS WILL SHORTEN LIFE OF LAMP!
MAKE SURE ALL COVERS/PANELS ARE REPLACED/SECURED BEFORE
OPERATING FIXTURE TO PREVENT ANY RISK AND/OR DAMAGE TO EYE
RETINA FROM UV RADIATION EXPOSIURE!
LAMP PROTECTION CIRCUITRY
Because of the nature of the extreme heat associated with the
Philips
MSD
Platinum 200 FLEX
lamp and the tight nature of the internal optical system, it is
IMPERATIVE
that the lamp be
replaced every
6,000 Hours
. This is done to protect the internal optical system as well as
prevent accidental lamp explosion, which could lead to hot glass particles falling from the
fixture.
At
6,000 Hours the LCD control display will begin to flash, “Replace The Lamp” and the
lamp will flicker for the first five minutes of operation. At this point the lamp has reached the
maximum rated life and should be replaced immediately. After the lamp has flickered for
about five minutes it should strike normally allowing the fixture to be used temporarily until
a replacement lamp can be installed.
After 6,000 Hours the fixture will no longer respond to DMX commands and immediately
enter a hibernation mode that will electronically discontinue all fixture functionality with the
exception of a few menu commands. The fixture will continue to enter hibernation mode
until the lamp is replaced and the lamp clock has been reset. To replace the lamp, follow the
instructions and procedures listed on the next page.