Power Wash 250™
©Elation Professionals® Los Angeles, Ca. 90058 -
www.ElationLighting.com
-
Page 18
3.1 Adjust
the
DMX-
Address
(D001)
After applying power to the
POWER WASH 250™
the LCD will display the
fixture’s current DMX address. If the fixture is not receiving a DMX signal the
display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the
POWER WASH 250™
and wait for the fixture reset process to
finished (
'
RESE
'
will flash in the LCD while fixture is in reset mode).
2. Press the
Mode
button to access the main menu. Toggle through the menu
by pressing the
Up
and
Down
buttons until the display shows
D001
. Tap the
enter button to make changes to the address, the current three digit address
will immediately begin to flash.
3. While the current three-digit address is flashing, use the
Up
and
Down
buttons
to select adjust the address. Lock your new address into by pressing
the
Enter
button. After the new address has been successfully stored into the
fixture’s memory the LCD will briefly readout
OK
.
The DMX address is non-destructible and will remain in the fixture’s memory
even when the power has been switched off. Memory is backed-up and retained
by an internal power source with a five year shelf life.
3.2 The Test Program
(TEST)
Test
The
Test
Program launched the fixture’s internal test mode. This function runs a
complete test procedure of all functions. Press
Enter
to launch the self-test or
the
Mode
button to cancel.
3.3 The Audio Program
(AUDI
The
Audio
menu allows you to run a stand-alone audio program. This program
can run either fast (
AFST
) or slow (
Aslw
); Fast (
AFST
): When running in “fast”
mode every sound impulse will trigger a new step. (
Aslw
): When running in You
may run several fixtures together at once to achieve a synchronized light show
