Power Spot 700™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page
17
2.7
5-Pin XLR DMX Connectors.
Some manufactures use 5-pin XLR connectors for
DATA transmission in place of 3-pin. 5-pin XLR fixtures may be implemented in a 3-
pin XLR DMX line. When inserting standard 5-pin XLR connectors in to a 3-pin line a
cable adaptor must be used, these adaptors are readily available at most electric
stores. The chart below details a proper cable conversion.
2.8
Fuse Requirements
The
POWER SPOT 700’s
electronic and lamp systems are protected by two GMA
(5x20mm) external fuses:
Lamp: 250v/10A (120v Operation)
or
250v/5A (220v Operation)
Electronics: 250v/2A (120v Operation)
or
250v/1A (220v Operation)
The fuse requirements are clearly printed on the side of the fixture.
WARNING:
•
Always disconnect main power before changing the fuse!
•
Always replace with the exact same type fuse unless otherwise specified
by an authorized Elation® service technician. Replacing with anything
other than the specified fuse can severely damage your fixture and will
void your manufactures warranty.
2.9
Transportation and Handling
The
POWER SPOT 700™
comes with two carrying handles built into the base.
Always transport the fixture by these handles. Never lift or carry the
POWER SPOT
700™
by the yoke (head assembly) this can seriously damage the unit and will void
your manufactures warranty.
