Elation E Spot Led II, User Manual

Page: 42 / 51

w w w . e l a t i o n l i g h t i n g . c o m
42
E SPOT LED II
™
User Manual 1.0
E R R O R C O D E S
When power is applied, the unit will automatically enter a “Reset/Test” mode. This mode
brings all the internal motors to a home position. If there is an internal problem with one or
more of the motors an error code will flash in the display in the form of “XXer” were as XX
will represent a function number. For example, when the display shows “0Er” it means there
is some type of error with the Pan motor. If there are multiple errors during the start-up
process they will all flash in the display. For example: if the fixtures has errors on channel 1,
Channel 2 , and Channel 5 all at the same time, you will see the error message “01Er”,
“02Er” , and ”05Er” flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a
second reset signal and try to realign all the motors and correct the errors, if the error persist
after a second attempt a third attempt will be made.
If after a third attempt all the errors have not been corrected the fixture will make the
following determinations:
1) 3 or more errors - The fixture cannot function properly with three or more errors therefore
the fixture will place itself in a stand-by mode until subsequent repairs can be made.
2) Less than 3 errors - The fixture has less than 3 errors, therefore most other functions will
work properly. The fixture will attempt to operate normally until the errors can be correct by a
technician. The errors in question will remain flashing in the display as a reminder of internal
errors.
PAN Error: The yoke is not located in the default position after start-up or after a reset
command. This message will appear after a fixture reset if the pan’s magnetic-indexing
circuit malfunctions (sensor failed or magnet is missing) or there is a motor failure (defective
motor or a defective motor IC drive on the main PCB). This error may also be displayed if the
head/yoke was blocked during a reset function.
TILT Error: This message will appear after a fixture reset if the tilt’s magnetic-indexing
circuit malfunctions (sensor failed or magnet is missing) or there is a motor failure (defective
motor or a defective motor IC drive on the main PCB). This error may also be displayed if the
head was blocked during a reset function.