-25-
DMX Triggering Function(DMX Control)
In this mode, all scenes(
) are available to be controlled and playback by addressing DMX address. And user may use DMX values
to control the desired scenes.
Before any DMX trigger operation, please ensure all of connections among of your E-NODE 8 and DMX Trigger
device(DTC-512 or X-Trigger-USB) with your computer are be connected properly.
1.When you use DTC-512 as DMX trigger device,
NOTE
:
Flash files-*swf, *GVI, Video Files-*AVI,*WMV, MPEG Files-*mpeg,*mpg,*mlv, *mp2,
*mp3
Basic Input Output System(BIOS) must be set up in Extended
Parallel Port(EPP) mode in your PC before operation. And the X-Soft-Net is available in the version1.06.
2.When you use X-Trigger-USB, the version of the X-Soft-Net must be Rev1.06.
Click the "DMX CTRL" icon to activate DMX Control function.
Enter the proper DMX starting addressing number as your desired before you can operate your DMX
controller. And sequential three DMX channels to control a scene. Please refer to the following table for
more details;
DMX Channel Selection
Starting Channel
Starting Channel
+1
Starting Channel
+2
DMX Values & Functions
0~127 to Normal Output,
129~255, allow to Blackout.
0~85 to Pause;
86~170 to Play;
171~255 to allow to Stop.
0 ~2, select Scene_1;
3~5, select Scene_2;
6~8, select Scene_3;
........
252~254, select Scene_85
DMX Channel Selection, DMX Value & Functions Table
The user can follows the below flow to close the hard acceleration of your computer:
Display Properties____> Settings____>advanced____>troubleshooting____>close Hard Acceleration
