Port State
is a read-only field showing the operating state of the port when only one port was selected.
The five possible states are
Blocking, Listening, Learning, Forwarding,
and
Disabled.
An asterisk (*)
appears in this field if you selected a group of ports in different operating states.
8.
Enter a value from
0-255
in the
Port Priority
field. This influences the choice of port when a bridge has
two ports connected in a loop. A lower numerical value gives that port a higher priority. The default is 128.
9.
Enter a value from
1-65535
in the
Port Path Cost
field. This cost value is added to the root path cost field
in a configuration BPDU received on this port to determine the cost of the path to the root through this
port. The default is 19 for ports set to 100Base-TX and 4 for Gigabit.
10.
Root Path Cost
is a read-only field showing the cost of the path to the root from this bridge. It is the sum
of the designated cost and path cost parameters specified for the root port. When the bridge is the root,
this number is 0.
11.
To save these entries, select
SAVE
and press the
Enter
key. You do not need to shut down or warm start
the Switch for any changes to take effect.
12.
To cancel the changes, select
EXIT
and press the
Enter
key.
13.
112
Summary of Contents for BitStorm L3S-T
Page 43: ...For more information also see VLAN Tagging Configuring GVRP Quality of Service 43 ...
Page 73: ... clear snmp community community_name Example clear snmp community support 73 ...
Page 106: ...Select Exit to leave this screen 4 106 ...
Page 139: ...Monitoring Performance Web version Unit Analysis System Resources 139 ...
