MEM-BUS
EtherNet/IP™ ENCODER
Instruction Manual
ENIP_Manual_ENG 17/07/2018
27
Attribute 2, Interface Flags
This attribute value is a bitmap, showing status and configuration information about the physical interface.
Bit0
Link Status
It indicates whether or not the communication interface is connected to an active network.
Bit1
Half / Duplex Link
0 indicates the interface is running Half-Duplex, 1 indicates Full-Duplex.
Bit2–4
Negotiation Status
Indicate the status of link auto-negotiation
= 0
, auto-negotiation in progress.
= 1
, auto-negotiation and speed detection failed; using default values for speed and duplex;
= 2
, auto-negotiation failed but detected speed; using default value for duplex.
= 3
, successfully negotiated speed and duplex.
= 4
, auto-negotiation not attempted; forced speed and duplex.
Bit5
Manual Setting Requires Reset
= 0, the interface can automatically adopt changes of attributes of the Ethernet Link Object,
without resetting for activation.
Bit6
Local Hardware Fault
= 0, indicates the interface detects no local hardware faults.
Bit7, …, Bit31
Reserved.
Attribute 3, Physical Address (MAC)
This attribute value contains the interface’s MAC layer address. The MAC address consists a 6 byte Ethernet
address for each individual device and it is unique worldwide. The MAC address consists of two parts, the
first 3 bytes represents the manufacturer-specific ID, while the last 3 bytes represents a consecutive
number. The MAC address for ELAP MEM-BUS encoder is 60-D7-E3-1x-xx-xx.
Attribute 4, Interface Counters
This attribute is a data structure consisting of 11 UDINT counters, concerning the receipt of packets on the
interface.
Attribute 5, Media Counters
This attribute is a data structure consisting of 12 UDINT counters, specific to Ethernet media.
Attribute 6, Interface Control
This attribute is a data structure consisting of
Control Bits
and
Forced Interfaced Speed
.
Control Bits:
Bit0
1 indicates the link auto-negotiation is disabled; in this case, the device shall use the
settings indicated by the Forced Duplex Mode and Forced Interface Speed bits.
Bit1
When the auto-negotiate bit is 0 (Bit0 = 0), it indicates whether the interface shall operate
in full or half duplex mode (0
Half Duplex, 1
Full Duplex).
Bit2, …, Bit15
Reserved, shall be set to 0.
Summary of Contents for MEM440-Bus
Page 1: ...1 MEM BUS ABSOLUTE ENCODER Instruction Manual ...
Page 40: ......
Page 41: ......
Page 42: ...MEM BUS EtherNet IP ENCODER Instruction Manual ENIP_Manual_ENG 17 07 2018 40 ...