EL-4KPM-VIP-CTRL/TX/RX
USER MANUAL
28
www.elanhomesystems.com
6)
Transmitter configuration
The below image is the Transmitter summary screen
From this configuration page you can:
1. Name the Source device the transmitter will be connected to (i.e. Apple TV, Laptop, Blu-Ray etc.)
2. Auto Assign IP - the PC Wizard will assign the product IP address as explained on page 23. Manual Assign IP - Installer can
manually assign IP address details. For example:
Please note: It is not advised that IP address of Video Over IP products be manually confugured as the ELAN EL-4KPM-VIP-
CTRL and drivers are configured to the default PC wizard IP address range. Manually assigning IP addresses will prevent the
EL-4KPM-VIP-CTRL control module from working.
3. Mode 1 - standard default setting that allows multiple Receivers (display) to view the source (Transmitters) at the same time.
4. Mode 2 - setting that limits each Transmitter (source) to only be viewed by a single display (Receiver) at the same time. This mode
is not advised.
Press ‘
CONTINUE
’ when finished to apply the changes to the ELAN Transmitter. You will note the Transmitter will automatically reboot
itself in order for the settings to be applied. This may take a couple of minutes.
Check the product is powered and connected and click ‘OK’ to try again.
5.
Repeat the Transmitter configuration process for all products.
Remember to not connect any additional Transmitter products until the previous unit has rebooted and
been assigned its new IP address.