![ELA SCIBT68B User Manual Download Page 9](http://html1.mh-extra.com/html/ela/scibt68b/scibt68b_user-manual_2375128009.webp)
Specifications could be modified without any notification. Non-contractual document.
Copyright © 2018 ELA Innovation
User Guide SCIEL
READER IP2 04B.docx
9/18
Image 13:
DIN rail mount
Remove the washer on the 2 screws of the
previous step. Keep them for later use.
Reassemble the whole unit. Don’t tighten the main
board’s screws too hard, otherwise you could
make dammages
!
Place the DIN CLIP 01 accessory as shown on the
image alongside, and screw it.
Now the reader can be mounted on a standard DIN
rail.
4
READER’S
OPERATING MODE
4.1
Physical setup
1.
Plug an antenna on the female SMA.
You can use the included SMA-Male -> BNC-Female
adapter. If your antenna has a BNC plug.
2.
If you want to use an external DC power supply, plug it
in the DC jack or wire it to the pins ‘G’ (ground) and ‘+’
(positive) of the 3 pins block.
3.
Plug the RJ45 cable to your local network and to the
Ethernet plug of the reader.
Figure 14:
Readers's LEDs working
For the following, refer to
3.4 LED Indicators
.
The reader’s
yellow LED must be on (blinking or permanent): that means the reader is correctly supplied.
The reader’s blue
LED must be on too: that means the network is working.
These two LEDs are surrounded by a red rectangle in the image above.