User Manual
Revision 0
2021-03-03
© 2021 Escape Logger
Page 23 of 35
Enabled_CVBatt
The ‘Enabled_CVBatt’ parameter enables or disables the
reading of the RTC battery voltage and writing it to the sensors
log file.
Permitted values:
o
0 = Disabled (Default).
o
1 = Enabled.
The RTC time is setup by following these steps:
1. Set the ‘Rtc_Time’ value in the configuration file to a time around 1 minute ahead of
the current time:
Time_01_Rtc_Time
= 2020-05-10T18:20:00
2. Set the ‘Rtc_set’ value that tells the logger you are wanting to set the RTC on the
next reset or power cycle:
Time_01_Rtc_Set
= 1
3. Save the configuration file changes.
4. Reset the logger by pressing the reset (“RST”) button or power cycling the device.
5. When the logger powers back up, the green and red LEDs will start flashing at 1 Hz,
indicating that it is ready to set the RTC to the value specified in the configuration file
above.
6. When the current time matches the time stored in the configuration file press the user
(“USER”) button once to get the logger to set its RTC to the time you set in ‘1’ above.
7. The green and red LEDs should stop flashing and the logger should start running in
normal mode of operation.
You can check that the logger RTC time is set correctly by checking the data log files or
streaming the data out of a serial port.
4.7
S
LEEP
S
ETUP
The switch on time can be set using the following parameter in the configuration file:
Time_01_Deep_Sleep_On
= 00:00:00.0
4.8
USB
S
ERIAL
P
ORT
S
ETUP
The USB serial port configuration parameter is as follows:
USB_01_Enabled_Serial
= 1
The permitted values are as follows:
Enabled
Enables or disabled the USB serial port from transmitting data.
Permitted values:
o
0 = Disabled (Default).
o
1 = Enabled.
