El Fuego AY0599, User Manual

Page: 57 / 59

28
EN
OPERATION
1 Check the voltage on the equipment label before use. Only connect the device to
sockets that correspond to the voltage of the device. If you are unsure whether your
connections meet the requirements, consult an electrician or your electricity supplier.
2 Place the drip tray under the beer faucet to avoid messes from excess beer.
3 Open the beer faucet by pulling the tap towards you to dispense the beer.
NOTE: If for any reason the beer does not come out of the tap, please refer to the
INSTALLING KEG TAP section.
4 Increase the pressure if the beer runs too slowly.
5 Hold the glass steady at a 45° angle. When it is 2/3 full, straighten the glass.
Proper foam should be a tight creamy head.
NOTE: It is normal to see condensation form on the faucet. It is caused by the
difference of temperature between the cold beer and the inside of the faucet when
beer is flowing through the line.