EN
Cleaning
• Always replace the filter after use.
• Clean externally with a mild soap solution and
a damp cloth. The display can be cleaned with
glass cleaner and a soft cloth.
• Air-blow the inside of the machine carefully,
then wipe with a damp cloth.
• Never use inflammable or combustible sol
-
vents near the machine.
NOTE!
All repairs to electrical parts must be per-
formed by a qualified professional or the
manufacturer.
TROUBLESHOOTING/CHECK LIST
The machine does not start
• Check that the fuses in the nearest electrical
cabinet are intact.
• Check whether the residual current device in
the nearest electrical cabinet has tripped.
• The machine has overheated and cannot be
restarted until the temperature has dropped.
• Check whether the fuses in the machine have
tripped. These are located beneath the inlet
behind the fuse cover.
TRANSPORTATION/STORAGE
The machine must always be transported upright. Before transporting the machine, fix the air distrib
-
utor in its lowered position if necessary. During transportation, the machine must be anchored to the
transport vehicle. The machine should only be lifted using the 4 lifting eyes on the sides of Module 1.
When the machine is not in use, store it indoors where it is dry and there is no risk of freezing.
SCRAPPING
Take the machine to a recycling station according to state or local regulations.
WARRANTY
El-Björn AB’s products and deliveries are regulated by Standard Agreement NL 09. Under these provi
-
sions, El-Björn AB is responsible for faults arising within one year from delivery.
The provisions of NL 09 also apply for professional parties who register according to the instructions
below, although with the following modification:
El-Björn AB is liable for faults arising within five years after delivery; this only applies to products
registered on the website.
In other respects, the provisions of NL 09 apply.
To obtain this extended warranty, you must register within 14 days from the date of purchase of the
products.
The machine emits too little air
• Check that the air distributor/vents are not
blocked.
• Check that the air inlet and filter are not
clogged.
• See the display instructions.
There is no hot air supply
• Check that the correct drying program has
been selected.
• Check whether the fuses have tripped. These
are located beneath the inlet behind the fuse
cover.
• Check whether the overheating protector has
tripped. The display will show a red warning.
If this fault occurs, contact a qualified professional
or the manufacturer.
