- 10 -
STEP 2
Optional Step 2.1 (Using the Front and Bottom Radiator –
GREEN
)
Install the following in this sequence: EK-Quantum Torque Extender
Rotary MF 14mm, EK-Quantum Torque Angled – 90°, and EK-
Quantum Torque HTC fitting on the radiator port closer to the
distribution plate. EK-Torque HTC fittings should be installed on the
other radiator port and the bottom two distribution plate holes.
Optional Step 2.2 (Using the Front Radiator Only –
RED
):
Execute the previous “
GREEN
” steps with an additional EK-Quantum
Torque Extender Static MF 28mm for the radiator port further from
the distribution plate.
After either of these steps, push the radiator on the bracket with
ports on the bottom, as seen in the image. Make sure you cut the
tubes just right, with the position of the radiator matching the
screw holes on the metal bracket. We suggest the shorter tube be
51 mm and the longer one 107 mm. Once you’re finished with the
placement, tighten the radiator screws.
Important:
Optional steps apply when using EK-
Quantum Surface P360 or P240 radiators, or in case of
S360 and S240 radiators when extra 14 mm extenders on
both radiator ports are needed.
STEP 2
TORQUE ROTARY
90° FITTING
14mm EXTENDER
28mm + 14mm
EXTENDER
FITTING
