- 15 -
CONNECTING THE D-RGB LED STRIP
Plug the 3-pin connector of the distribution plate’s D-RGB LED
light into the D-RGB HEADER on the motherboard. The LEDs will
work if the pin layout on the header is as follows:
+5V, Digital,
Empty, Ground.
D-RGB Header
RGB Header
CONNECTING THE PUMP
The EK DDC 4.2 PWM pump has two connectors.
1. SATA Connector:
It must be connected directly to your PSU at all
times since it powers the pump.
2. 4-Pin PWM Fan Connector:
It can be connected to your
motherboard’s CPU, fan, or designated water pump header. It
can also be connected to a controller. This cable controls and
reports the rotational speed of the pump. The pump will run at its
maximum speed (100% PWM) if not connected.
SATA
CONNECTOR
4-PIN PWM FAN
CONNECTOR