ekwb EK-MLC PHOENIX Series, User Manual, Page: 23 / 40

/ 21 /
STEP 8
Cleaning the CPU: Wipe the CPU’s contact surface (by using non–
abrasive cloth or Q-tip, as shown on sample photo).
Applying thermal compound:
EK recommends blob or line method of
applying the enclosed compound to the CPU heat spreader (IHS) - see
sample photo on right.
The quantity of about two rice grains is just about right. There
is no need to cover the whole IHS. Applying too much thermal
grease will have negative impact on the cooling performance!
STEP 9
Align water block with pre-installed mounting mechanism above the
AMD socket with pre-installed CPU. Place an enclosed coiled spring
and thumb nut over each M4 thumb screw. Start fastening two thumb
nuts at a time, preferably in cross pattern and do not tighten them fully
until all of them are partially screwed in.
Then – using your fingers only screw in all four thumb nuts until you
reach the end of the thread.
CPU Module installation is now complete. Continue to page 22 for
connecting the module with QDC.
STEP 8
Non-abrasive
cloth
IHS
Th
erm
al g
reas
e
STEP 9