CLEANING
Before carrying out any of the following operations, ensure that the fire is OFF and completely cold.
Debris that may form on the firebed should be periodically removed by a competent person. Large deposits
could indicate deterioration of the flue. This should be repaired by a competent person, and the fire serv-
iced before further use.
STAINLESS STEEL AREAS - These parts may be cleaned using an appropriate metal polish. Clean only in the
direction of the grain. Alternatively, a small amount of baby oil applied in the direction of the grain, with a
soft, lint free cloth.
Another effective way to restore the ‘as new’ look to the stainless steel parts, is use of a proprietary car inte-
rior cleaning agent such as ‘Cockpit shine’. This should be sprayed directly on to the metal and then wiped
off with a clean lint free cloth.
It is strongly recommended to test clean on a small inconspicuous area firstly to ensure the cleaning sub-
stance(s) are suitable.
Before cleaning, always ensure that the fire is OFF and completely cold.
PAINTED AREAS - These can be cleaned using a dry cloth.
PEBBLES AND CERAMICS -Remove the ceramic components. Gently clean with a soft brush in the open air. Do
not create dust from the pebbles. Where necessary replace damaged components with genuine spares. Seal
scrap components in plastic bags and dispose of at proper refuse sites as directed.
Do not attempt to wash or otherwise clean any ceramic part using water as this will destroy them.
Re-fit the pebbles carefully by referring to the relevant section of these instructions.
LIST OF SPARES
PART NO.
ITEM
F550134
Pack of 13 hand decorated pebbles, and combustion matrix.
F550133
Pack of 3 ceramic tiles.
F730006
Pilot unit
F710638
Stainless steel shelf assembly
F710640
Stainless steel door assembly
7.0
8.0
5
F860629
©
2009 Focal Point Fires plc.
As our policy is one of continuous improvement and development , we hope therefore you will understand we must retain the right to amend details and/or spec-
ifications without prior notice.
[1] GB - Gas Safe
TM
registered operatives (Northern Ireland only- CORGI registered operatives) are the only class of person considered as competent by the HSE under the
Gas Safety (Installation and Use) Regulations 1998.
Summary of Contents for eko 2030
Page 2: ...Eko 2030...
