20
The truck signal detection
Connect Handle programmer to controller
then turn on the key switch
According to the menu list of CURTIS Handle programmer, find: Monitor.
If necessary, Open the corresponding sub-item of the detection menu. R u n the truck and observe
the change of value
CURTIS Handle programmer Manual content
Curtis 1313 handheld programmer is used to configure the Curtis electronic control system. Through this
programmer, you can adjust and save the set parameters, real-time monitoring of controller data and fault
diagnosis
The programmer has 2 interfaces, one is used to
communicate with the electronic
Control, t h e other is used to communicate
with the PC, the programmer has a battery box and a
memory card Slot
Power on the handle programmer
Insert the connecting wire of the handheld programmer into the programming port of the controller. After
connecting to the controller, the handheld programmer will automatically power on and display the
control information on the programmer
Warning: The control system will affect the
acceleration rate, deceleration rate, hydraulic
system, and brakes of the truck. If the truck control
system is programmed incorrectly or exceeds
safety, a dangerous situation will occur. Only the
truck manufacturer or an authorized service agent
can program the control system
