BIOS Quick Reference • CC5-RAVE
- 17 -
EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany)
Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail [email protected] * Internet http://www.ekf.de
IDE Configuration Setup Screen
This screen provides for configuration of both the Primary IDE and the Secondary IDE interfaces.
Each port can be individually enabled/disabled.
Primary IDE Port
UDMA66
On the CC5-RAVE, the primary IDE port is dedicated to the harddisk (master) and CD-ROM
(slave) drives. Normally, this port must be enabled. You can select the method how the disk
operating system will detect attached drives at the Primary IDE interface as Ultra ATA/66. You
will have to distinct between two hardware configurations:
1. The CC5-RAVE comes without the super-I/O companion board CC6-ACID. The UDMA options
at your choice are ‘Dis’ (disable, never allow UDMA disk operation) and ‘Auto’ (the IDE cable
type in use, 40- or 80-pos., is detected in order to check if UDMA operation could be allowed).
2. The CC5-RAVE is accompanied by the CC6-ACID Low-Pin-Count super-I/O interface board,
usually with the harddisk being mounted directly to this card. The available options are ‘Dis’
(never allow UDMA), ‘Auto’ (for auto-detecting of 80-pos. IDE cables), and ‘Ena’ (for simulating
the 80-pos. IDE cable being present - this option is required for an HDD directly mounted on the
CC6-ACID).
