BIOS Quick Reference • CC5-RAVE
- 11 -
EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany)
Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail [email protected] * Internet http://www.ekf.de
"Not installed" for drives that are not installed.
Miscellaneous Settings
Typematic Delay/Rate
These parameters configure the keyboard interface and define the repetition rate of the
characters. Normally you do not need to change these parameters.
Seek at Boot
This option defines drives to which drive a "SEEK" command is sent before the boot procedure.
You can select ‘NONE’ (no drive), ‘FLOPPY’ (floppy drive A), ‘IDE’ (IDE drive C) and ‘BOTH’
(floppy and IDE drive). The default setting is ‘NONE’ to make the boot procedure as short as
possible.
Show "Hit Del"
If this option is active, you have the choice to enter the Setup menu during the power-on self
test. To do this, press the <Del> key (with monitor/keyboard) or <Ctrl> + <C> (with
terminal).
Config Box
This option determines whether or not the configuration table is displayed on the boot console.
F1 Error Wait
If this option is active, the power-on self test will halt when detecting an error, and will prompt
you to determine how to proceed. If you press <F1> the POST will continue despite the error,
if you press <Del> you will enter the Setup menu and can check the configuration.
Parity Checking
This menu item is not used. It has no function.
Memory Test Tick
If this option is active, a click signal will be output on the speaker during the power on self test.
Test Above 1 MB
This option defines whether the memory area above 1MB will be tested during the POST.
