Drawing : TPC465
Issue
: C
Date
: 05/01/2017
INSTALLATION
The DD3000 is designed for indoor use. The unit should be placed on a level
surface and a space of 1 meter free around all faces to allow access for any
duct work and servicing.
Connecting duct work:
The regeneration outlet must be ducted to outside the area being
dehumidified. The outlet duct spigot is 10” diameter and only 10” ducting or
greater should be attached. A damper for adjusting the airflow must be
installed
The process outlet can be ducted to a specific area or another room. The
outlet duct spigot is 16” diameter and only 168” ducting or greater should be
attached.
Both the regeneration and process air inlets are provided with filters. The
dimensions of the ducts are as follows:
Process air inlet L 740mm x W 535mm (29.1” x 21”)
Regeneration air inlet L 485mm x W 485mm (19.1” x 19.1”0
Power Supply & Humidistat Control:
The unit must be connected to a suitable 460V, 3 phase, 50Hz supply.
Feed power cables through the gland provided and then wire the unit as
shown below.
An external humidistat can also be used to control the relative humidity in the
dehumidified area. If a humidistat is used then the wires should pass through
the gland provided and then wired as shown in the diagram at the back of this
manual.
-WARNING
-
THIS APPLIANCE MUST BE EARTHED
