9
GB
Trouble Shooting
Problem
Cause
Remedy
Motor doesn’t start
No electricity
- Check electrical outlet
- Check mains cable
Piezo doesn’t ignite
Electrode incorrectly adjusted
Check electrode and precisely
set according to diagram
No gas at burner
- Gas valve is closed
- Open valve
- Gas cylinder is empty
- New gas cylinder
- Gas hose or connection leaks
- Locate point of leak with soap
-
foam and repair
Burner ignites, flame is
- The thermoelement was not
- Repeat ignition procedure
extinguished as soon as the gas
-
warm enough
-
while pressing in the gas
valve is released
- The safety thermostat
-
valve knob
-
-
switches off
- Allow the heater to cool for a
-
few minutes and reignite
Burner goes out while in use
- Gas flow too high
- Have the pressure regulator
- Air input too low
-
inspected and replace if
-
necessary
- Check the suction grid and
-
clean
- Inspect ventilator
Important!
Have repairs carried out only by specialist workshops or ISC.
Anleitung HGG 350 8-sprachig 06.11.2001 13:53 Uhr Seite 9
