GB
- 19 -
4. Technical data
See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Wear ear-mu
ff
s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Warning!
The speci
fi
ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the speci
fi
ed value
in exceptional circumstances.
The speci
fi
ed vibration value can be used to
compare the equipment with other electric power
tools.
The speci
fi
ed vibration value can be used for initi-
al assessment of a harmful e
ff
ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect con-
ditions.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Assembling the grass trimmer
(Fig. 3a to 3c)
•
Place the guard hood (Fig. 3a/Item 12) on the
motor head and fasten it to the motor head
with the screw (Fig. 3b/Item A).
•
Place the distance bracket (Fig. 3c/Item 9) on
the motor head as shown in Fig. 3c and fas-
ten it with the screws (Fig. 3c/Item 14).
5.2 Adjusting the additional handle
(Fig. 4a and 4b)
Place the grass trimmer on a
fi
rm surface. Swing
back the lock (Fig. 4a/Item 5) and adjust the addi-
tional handle to the optimum position for yourself
(see Fig. 4b). Swing the lock shut (Fig. 4b/Item. 5)
to fasten the handle.
5.3 Height adjustment (Fig. 5)
You can set your optimal working position by ad-
justing the height.
•
Undo the lock for the handlebar adjustment
(Fig. 5/Item 6).
•
Pull out the bottom handlebar (Fig. 5/Item 8)
to the required length.
•
Refasten the lock for the handlebar adjust-
ment (Fig. 5/Item 6).
5.4 Adjusting the angle of the handlebar
(Figure 6)
When the lock is pressed (Fig. 6/Item 15) you can
adjust the angle of the handlebar to 5 positions.
Set the angle which is best suited for your work.
Make sure that there is an audible click when the
handlebar engages.
Anl_SA_GC_ET_4526_SPK8.indb 19
Anl_SA_GC_ET_4526_SPK8.indb 19
18.04.16 09:58
18.04.16 09:58
