![background image](http://html.mh-extra.com/html/einhell/fbs-62a/fbs-62a_assembly-instructions-manual_2371061006.webp)
GB
6
List of parts
a) Aluminum profiles
Item
Description
Length
Qty
Replacement part
no.:
1
U-shaped longitudinal profile
940 mm
3
368041001001
2
U-shaped side profile
535 mm
2
368041001002
3
H-shaped side connector
300 mm
2
368041001003
4
U-shaped hood profile - front
908 mm
1
368041001004
5
U-shaped hood profile - side 1
227 mm
2
368041001005
6
Hinge profile 1
960 mm
2
368041001006
7
U-shaped hood profile - side 2
253 mm
2
368041001007
8
Hinge profile 2
940 mm
2
368041001008
9
U-shaped side profile
545 mm
2
b) Plastic web panels
Item
Description
Length
Qty
Replacement part
no.:
10a
Hood half 1
270x966x4 mm
1
368041001009
10b
Hood half 2
270x966x4 mm
1
368041001010
11
Front section
1485x320x4 mm
1
368041001011
12
Rear section
1485x365x4 mm
1
368041001012
c) Other
Item
Description
Qty
Replacement part
no.:
20
Hinge clamp
4
368041001020
21*
Assembly corner
4
22*
Hood corner piece
2
23*
Earth pegs
4
24*
Clips
6
25
Self-tapping screw 2.9 x 6.5 mm
2
368041001025
*Item 21, 22, 23 and 24 are only available as a complete set - replacement part number: 368041001021
Choosing a place in the garden
Choose a place in the garden for your cold frame. The cold frame must be screwed to a level baseplate, or
the ground must be level around the area of the side panel so that it can be fixed to the ground with the earth
pegs (23).
To assemble the cold frame you will need a light hammer and a pocket ruler.
Before assembly, please read the instructions very carefully and study the pictures closely. When fitting the
profiles to the plastic web panels always check the length of the profiles and only fit them to the plastic web
panels when you are sure that you have the correct profile.
Ideally, you should lightly grease the edge of the plastic web panel or the profile with cooking oil or fat. You
will then be sure to tap on the profiles gently with the heels of your hand or a hammer. Check that the plastic
web panels do not have any burrs on the cutting edge. If burr is present, you must remove it by carefully
scraping it with a knife.
Anleitung FBS 62 A 06.10.2004 14:16 Uhr Seite 6