11
GB
Warning: To prevent danger for very young children it
is recommended to install this equipment such that
the bottom heated bar is at least 600 mm above the
floor (Fig. 2).
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Operating status indicator
2. Heat output switch
3. Thermostat
control
4. Air
outlet
5. Towel
holders
3. Items supplied (Fig. 3-5)
n
Open the packaging and take out the equipment
with care.
n
Remove the packaging material and any
packaging and/or transportation braces (if
available).
n
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
transport damage.
n
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys! Do not let children play with plastic bags,
foils or small parts! There is a danger of
swallowing or suffocating!
n
Bath heater (6)
n
Wall holder for bath heater (7)
n
Narrow holding bar (8)
n
Wide holding bar (9)
n
Plastic cover (10)
n
Wall holder for holding bars (11)
n
Installation material
n
Original operating instructions
4. Intended use
The equipment is designed for use as a wall-mounted
heater in the bathroom, WC, cellar, hobby room etc.
The equipment may be used only for its intended
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
which result from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data:
Rated voltage:
230 V ~ 50 Hz
Heat output:
2000 W
Thermostat control:
Infinitely adjustable
Protection class:
II
Protection type:
IP 24
6. Before starting the equipment
1. Fig. 3: Push the two holding bars (8 / 9) into the
slots provided in the wall holder (11).
2. Fig. 3: Secure the holding bars (8 / 9) with the
screws (a) and the hexagon nuts (b) to the wall
holder (11).
6.2 Wall-mounting
The equipment is allowed to be mounted only on a
wall. The minimum clearances must be observed.
The equipment is allowed to be used only when it is
completely assembled and in a vertical position.
Important! Make sure that there are no electric cables
or other installations (for example water pipes) near
the drill holes. Ensure that the equipment is secured
firmly and horizontally to the wall. Use only suitable
fastening material on a wall capable of bearing the
load. The supplied dowels and screws are suitable for
the following: concrete, natural stone with a dense
structure, solid brick, solid limestone bricks, solid
lightweight concrete bricks and aerated concrete.
1. Fig. 3: Observe the minimum distance of 60 cm
from the bottom holding bar (9) to the floor. Mark
Anleitung_BH_2000_SPK7__ 21.05.12 12:01 Seite 11
