Avoid contact with leaky batteries. In the event of
contact, wash the affected area of skin
immediately with water and soap. If battery acid
gets in your eye, rinse out the eye with water for
at least 1 minute and consult a doctor at once.
Protect the battery charger and cable from
damage and sharp edges. Damaged cables are
to be replaced without delay by an electrician.
3. Items supplied
1 cordless multi-saw
1 replaceable battery 14,4 V
1 saw blade
1 battery charger with charging adapter
4. Technical data
Stroke rate:
3000 min
-1
Blade stroke:
16 mm
Cutting capacity max.:
40 mm diameter
Blade length:
90 mm
Weight of saw (w/o packaging):
1.78 kg
Sound pressure level:
79 dB(A)
Sound power level:
89 dB(A)
Vibration:
5 m/s
2
NC battery:
14,4 V
Power supply unit:
Mains voltage:
230 V ~ 50 Hz
Output:
Rated voltage:
18 V
Rated current:
0.4 A
5. Putting into operation
Charging the NC battery
Pull the battery out of the handle by depressing
the catches on the side (1).
Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. You can now plug the battery charger in
a socket-outlet.
Insert the battery in the charging adapter. An
empty battery requires a maximum charging
period of 12 hours. A battery with residual
capacitance takes accordingly less time to
charge. The temperature of the battery may rise
slightly during the charging operation. This is
normal.
Please note!
No automatic switch-off when the battery is fully
charged!
If the battery fails to charge, please check
whether there is voltage at the socket-outlet
whether there is good contact at the charging
contacts of the battery charger
If you still fail to charge the battery, please return
the power supply unit with charging adapter, and
the battery
to our ISC Service Centre.
In the interest of long battery life, recharge the NC
battery punctually. Recharging is always necessary
when you notice that the power of your multi-saw is
decreasing.
Never allow the battery to discharge completely. This
will cause a defect in the NC battery!
Inserting the saw blade
First take the battery out of the saw each time you
want to insert the saw blade.
6
GB
1
Anleitung AMS 14,4 07.11.2001 11:30 Uhr Seite 6
