6
GB
the screwdriver drops.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
7.2 ON/OFF changeover switch (Fig. 2/Item 2)
You can select between clockwise and counter-
clockwise rotation.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe this
point, the gearing may become damaged.
7.3 Angle setting (Fig. 1/Item 5)
The screwdriver can be locked into 2 different angle
settings. To do so, press the locking button (5) and
move the screwdriver into the desired position. Then
release the locking button (5).
Important. Before you switch on the screwdriver,
make sure that it is correctly locked in the angle
position in question.
7.4 Changing the tool (Fig. 3)
Important!
Insert the bit (A) into the bit chuck (1).
To remove the bit (A), pull it back out of the bit chuck
(1).
7.5 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
10. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Anleitung_BT_SD_3_6_Kit_2_SPK7:_ 01.06.2010 8:41 Uhr Seite 6
