EINHELL 41.713.25, Assembly And Operating Instructions Manual

Page: 13 / 52

working temperature
앬 Use only engine oil (10W40).
앬 Place the machine on a slightly inclined surface
so that the oil drain plug is at the lower end (Fig-
ure 7 / Item A).
앬 Remove the oil filler screw (Figure 7 / Item B).
앬 Remove the oil drain plug and drain the warm en-
gine oil into a suitable container.
앬 After all the oil has drained, screw in the oil drain
plug and place the machine on a flat surface.
앬 Insert fresh engine oil up to the top mark on the
oil dipstick (Figure 8 / Item H).
Important. Only
inset the oil dipstick to check the oil level. Do not
screw it in.
While the machine is working, the oil level must be
between the two marks “L” and “H” (Figure 8).
Dispose of the waste oil properly.
9.2 Air filter
Clean the air filter at regular intervals, and replace it if
necessary.
앬 Remove the air filter cover (Figure 9-10)
앬 Remove the filter insert (Figure 11)
앬 Clean the air filter by tapping it, blowing it out
with compressed air or by washing it with soap
suds.
Important. Leave the air filter to dry before
you refit it.
앬 Assemble in reverse order.
9.3 Spark plug
Clean the spark plug at regular intervals, and replace
it if necessary. Set the electrode gap to 0.6 mm.
앬 Remove the spark plug boot by twisting it (Figure
12)
앬 Remove the spark plug using a spark plug
wrench (Figure 13)
앬 Clean the spark plug with a copper wire brush or
fit a new one.
앬 Assemble in reverse order.
9.4 Fuel filter
앬 Remove the fuel line (Figure 14)
앬 Unscrew the fuel filter from the tank (Figure 15)
앬 Clean the fuel filter with compressed air. Ensure
that you do not damage the filter.
앬 Assemble in reverse order.
10. Storage
앬 Rinse the pump thoroughly with water before
lengthy periods of inactivity or winter storage.
앬 Close the petrol cock and allow the engine to run
until it stops to empty the carburetor.
앬 Fill the tank fully to prevent rust formation.
앬 Remove the drain plug (Figure 1 / Item 6) and
fully drain the pump housing.
앬 Store the machine in a dry place out of the reach
of children.
11. Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
13
GB
Anleitung RPB 18_SPK1:Layout 1 14.01.2008 9:21 Uhr Seite 13