EINHELL NEW GENERATION 34.036.70, Operating Instructions Manual

Page: 16 / 64

16
GB
Only then are you to remove the cause of
the obstruction.
19. Keep the hedge trimmer in a dry place out
of children’s reach.
20. During transportation and storage of the
hedge trimmer, keep the blades covered
at all times with the special guard.
21. Take care not to overload the hedge trim-
mer and do not use it on jobs for which it
is not intended, i.e. you are allowed to use
the hedge trimmer only to cut hedges,
shrubs and perennials.
22. Use only cables and connectors approved
for outdoor use: power cable HO7RN-F
2x1.0 with integral two-plug plug; extensi-
on cable HO7RN-F 3G1.5 with rain-water-
protected earthing-pin plug and earthing-
contact coupling.
The use of a leakage-current or earth-lea-
kage circuit-breaker is recommended for
operating electric tools. Ask your electrici-
an!
23. The hedge trimmer requires regular ins-
pection and maintenance. Always replace
damaged blades in pairs. If the hedge
trimmer suffers any damage from impact
(falling on hard ground etc.), have it
checked immediately by a specialist.
24. Look after your hedge trimmer carefully.
Keep it clean and sharp to ensure efficient
and safe cutting. Follow the maintenance
and cleaning instructions.
25. The German Farmers Union, for example,
prohibits the use of electric hedge trim-
mers by persons aged 17 or less. Persons
aged 16 and above may only use electric
hedge trimmers if supervised by an adult.
26. Do not use the hedge trimmer with a
damaged or excessively worn cutting
system.
27. Never try to work with an incomplete
machine or a machine with unapproved
modifications.
28. Check your surroundings and take note of
any potential dangers which you may not
be able hear due to the machine’s noise.
29. It is advisable not to use the hedge trim-
mer when other persons, and particularly
children, are nearby.
30. Children are not allowed to use the hedge
trimmer.
31. The machine may exceed 85 db (A) at
the workplace. The operator will require
noise protection measures and ear muffs
if this is the case. The noise generated by
this electric tool is measured in accor-
dance with EN 50144-2-15.
32. Vibrations on the handle were measured
in accordance with EN 50144-2-15.
2. Layout (see Fig. 1)
1. Cutter rail
2. Fixing screw
3. Hand guard
4. Front button switch
5. Front
grip
6. Slide
7. Swivel
handle
8. Button switch, inside
9. Button switch, outside
10. Slide
11. Power cable
12. Cable grip
13. Impact guard
14. Cutter guard
15. Cuttings collector
Important! You must never use the hedge
trimmer without wearing gloves.
3. Explanation of the plate
(see Fig. 2)
1. Warning
2. Keep out of the rain and protect from
getting wet.
3. Read the operating instructions before
using for the first time.
4. Pull the plug from the power supply
immediately if the cable gets damaged or
severed.
5. Wear goggles and ear muffs.
Anleitung NHS 700_SPK1 01.09.2006 11:37 Uhr Seite 16